[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove tires. Refer to Removal and InstallationRemoval & Installation.
2. Remove engine under cover. Refer to Exploded View.
3. Separate stabilizer connecting rod (strut side) from strut. Refer to Removal and Installation.
4. Remove steering outer socket from steering knuckle. Refer to Removal and Installation.
5. Separate transverse link from steering knuckle. Refer to Removal and Installation.
6. Disconnect steering gear and linkage harness connectors.
7. Remove rear torque rod. Refer to Removal and Installation.
8. Remove front exhaust tube mounting bush. Refer to Exploded View.
9. Secure the radiator and condenser to the vehicle.
10. Set suitable jack under front suspension member.
caution
  • At this step, the jack must be set only for supporting the removal procedure. For details on jacking up the vehicle, refer to Garage Jack and Safety Stand and 2-Pole Lift.
  • Never damage the front suspension member with a jack.
  • Check the stable condition when using a jack.
11. Remove member stay.
12. Remove front suspension member mounting bolts.
13. Gradually lower the jack to remove front suspension member from vehicle body.
cautionOperate while checking that jack supporting status is stable.
noteRemove suspension member with stabilizer bar and transverse link.
14. Remove the following parts.
15. Perform inspection after removal. Refer to InspectionInspection.
 
 
INSTALLATION
Note the following, and install in the reverse order of removal.
  • To install member stay and mounting bolts of front suspension member, temporarily tighten the bolts before tightening to the specified torque, referring to the tightening method and the numerical order shown below:
    Temporary tightening: 1 → 2
    Final tightening (Specified torque): 3 → 4 → 5 → 6 → 7 → 8 → 9 → 10 → 11 → 12
    : Vehicle front
  • Perform final tightening of bolts and nuts at the vehicle installation position (rubber bushing), under unladen conditions with tires on level ground.
  • Perform inspection after installation. Refer to InspectionInspection.