[Previous][Next]
DTC B1021: Blower fan SW
 
 
 
 
DTC SET CONDITION
DTC B1021 will be set when the A/C control panel cannot receive the signal of blower knob.
 
 
 
TROUBLESHOOTING HINT
  • Malfunction of the A/C control panel.
 
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus line
(1)
cautionTo prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line. (Refer to GROUP 54C, Diagnosis ).
 
STEP 2. Recheck for diagnostic trouble code.
Recheck if the DTC is set.
(1) Erase the DTC.
(2) Turn the ignition switch to "ON" position.
(3) Check if the DTC is set.
Is the DTC set?
Replace the A/C control panel.
It can be assumed that this malfunction is intermittent. Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions .