[Previous][Next]
DTC U1120: Bus line (CAN-C) low input
DTC U1121: Bus line (CAN-C) high input
 
 
 
 
TROUBLE JUDGMENT
When the CAN bus line voltage is in the following states, the ETACS-ECU set the DTC.
  • If the CAN bus line voltage is 0.3 volt or less, DTC U1120 is set.
  • If the CAN bus line voltage is 4.7 volts or more, DTC U1121 is set.
 
 
TROUBLESHOOTING HINTS
  • The CAN bus line may be defective.
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
(1)
cautionTo prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line. (Refer to GROUP 54C, Diagnosis ).
 
STEP 2. Recheck for diagnostic trouble code.
Check again if the DTC is set to the ETACS-ECU.
(1) Erase the DTC.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Check if DTC is set.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the DTC set?
Replace the ETACS-ECU.
The diagnosis is complete.