52A-FRONT SEAT BELT REMOVAL AND INSTALLATION

REMOVAL AND INSTALLATION

caution

SRS: Before removing and installing the seat belts with pre-tensioner, refer to GROUP 52B - SRS Service Precautions

and Seat Belt with Pre-tensioner

Pre-removal and Post-installation Operation

Turn the ignition key to the LOOK (OFF) position.

		Outer seat belt removal steps
	•	Disconnect the negative (-) battery terminal.
	•	Lower center pillar trim (Refer to ).
	1.	Outer seat belt mounting bolt
	2.	Seat belt pre-tensioner connector connection (GROUP 52B- Seat Belt with Pre-tensioner ).
	3.	Outer seat belt assembly (GROUP 52B - Seat Belt with Pre-tensioner ).
<<A>>	4.	Center pillar trim cap
	5.	Center pillar trim upper (Refer to ).
	6.	Front seat belt anchor adjustable
		Inner seat belt removal steps
	7.	Harness connector
	•	Side shield cover (Refer to ).
	8.	Inner seat belt (Refer to ).

REMOVAL SERVICE POINT

<<A>> CENTER PILLAR TRIM CAP REMOVAL

Remove the opening trim. Remove the trim cap by inserting the special tool ornament remover (MB990784) between the trim and body as shown in the illustration.