[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation Operation
Removal and Installation of Front Pillar Trim, Center Pillar Trim Upper, Quarter Trim Upper (Refer to ).
Removal steps
1.Roof inside assist grip (driver’s side) <Vehicles with curtain air bag>
2.Assist grip cover
3.Roof inside assist grip
4.Front dome light assembly (Refer to GROUP 54A - Dome Light ).
5.Security alarm sensor cover
6.Sun visor
<<A>>7.Sun visor holder
8.Headlining garnish (front) <Vehicles with roof window glass>
9.Headlining garnish cover (rear) <Vehicles with roof window glass>
10.Headlining trim
11.Rear dome light assembly (Refer to GROUP 54A - Dome Light ).
<<B>>12.Headlining
13.Headlining garnish <Vehicles with roof window glass>
14.Spot light assembly
Curtain air bag module mounting bolt (Refer to GROUP 52B - Curtain Air Bag Module ).
15.Assist grip bracket
16.Map light bracket
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> SUN VISOR HOLDER REMOVAL
Insert the special tools ornament remover (MB990784) into the sun visor holder from its left and right sides to disengage the claws on the sun visor holder sides.
 

 
 
<<B>> HEADLINING REMOVAL
To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.
Remove the headlining by inserting the special tool in the clearance of the dual lock fastener. <Vehicles with roof window glass>