STEP 1. Check KOS-ECU connector C-08 and inside transmission antenna assembly (front) connector C-19 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
STEP 2. Check the wiring harness between KOS-ECU connector C-08 (terminal Nos. 31, 43) and inside transmission antenna assembly (front) connector C-19 (terminal Nos. 1, 5).
STEP 4. Check whether the diagnostic trouble code is reset.
(1) Erase the DTC.
(2) Turn the power supply mode of the engine switch from OFF to ON.
(3) Check if the DTC is set.
Is the DTC set?
Replace KOS-ECU and register the ID codes (Refer to ). The procedure is complete.