[Previous][Next]
DTC C1788 Longitudinal G sensor signal
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
FCM/LDW/AHB-ECU communicates with the ASC-ECU via the CAN bus lines.
 
 
DTC SET CONDITION
This DTC is set when the abnormality below is detected:
  • The ECU receives an invalid longitudinal G-sensor signal from the ASC-ECU.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Malfunction of the ASC-ECU
  • Malfunction of the FCM/LDW/AHB-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.
Use scan tool to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. Check whether the DTC is set again.
Check again if the DTC is set in the FCM/LDW/AHB-ECU.
(1) Erase the DTC.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Check if DTC is set.
Is the DTC set?
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ) and then go to Step 3.
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 3. Check whether the DTC is set again.
Check again if the DTC is set in the FCM/LDW/AHB-ECU.
(1) Erase the DTC.
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Check if DTC is set.
Is the DTC set?
Replace the FCM/LDW/AHB-ECU (Refer to ).
This diagnosis is complete.