Do not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.
1. Check the clutch pedal.
2. Connect an ohmmeter to the clutch switch connector, and then check for continuity when the clutch pedal is fully depressed and when it is released outward.
Tester connection
Pedal position
Specified condition
1-2
Fully depressed
Continuity (Less than 2 ohms)
Released
Open circuit
3. If the continuity is incorrect, replace the clutch switch (Refer to ).
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
).