[Previous][Next]
DTC P1E0E: PTC heater voltage sensor circuit abnormality (rationality)
 
 
 
 
MONITOR EXECUTION
  • Continuous
 
 
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)
Other Monitor (There is no temporary DTC set in memory for the item monitored below)
  • Not applicable
Sensor (The sensor below is determined to be normal)
  • Not applicable
 
 
DTC SET CONDITIONS
Check Conditions
  • Battery management unit (BMU) power supply voltage is 8 volts to 16 volts.
  • Time after above conditions satisfy is more than 1 seconds.
  • PTC heater contactor (P) drive relay ON.
  • PTC heater contactor (N) drive relay ON.
  • Main drive lithium-ion battery PTC heater main relay ON continues 0.2 second.
Judgment Criterion
  • The absolute value of the difference between the value of PTC heater output voltage and the value of the battery voltage changes to 17 volts or more and the state continues for 3.0 seconds.
 
 
FAIL-SAFE AND BACKUP FUNCTION
  • Not available
 
 
PROBABLE CAUSES
  • The main drive lithium-ion battery PTC heater is failed.
 
 
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Recheck if the DTC is set.
(1) Erase the DTC.
(2) Depress the brake pedal, and turn on the power supply mode of the electric motor switch (READY operation)*.
note*: When a DTC is set, you cannot make the READY (ready to drive) indicator illuminate by making the READY operation.
(3) Check if the DTC is set.
Is the DTC set?
Remove the battery tray cover (Refer to ). Replace the main drive lithium-ion battery PTC heater (Refer to ). Then, assemble the main drive lithium-ion battery assembly (Refer to ).
Go to Step 2.
 
STEP 2. Using scan tool (M.U.T.-IIISE), check the data list <BMU>
Check the BMU's data list (refer to ).
  • Item No.438: BAT. heat initial judge. end flag
Is the value of data list "ON"?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Go to Step 3.
 
STEP 3. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
(1) Depress the brake pedal, and turn on the power supply mode of the electric motor switch (READY operation)*.
note*: When a DTC is set, you cannot make the READY (ready to drive) indicator illuminate by making the READY operation.
(2) Select "BMU" from System select Screen of the scan tool (M.U.T.-IIISE).
(3) Select the "Special Function" from the BMU screen.
(4) Select the "Test" from the Special Function screen
(5) Select the "Battery heating system drive" from the Test screen.
note"Battery heating system drive" can be performed only once after the power supply mode of the electric motor switch is turned ON.
(6) Check if the DTC is set.
Is the DTC set?
Remove the battery tray cover (Refer to ). Replace the main drive lithium-ion battery PTC heater (Refer to ). Then, assemble the main drive lithium-ion battery assembly (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).