[Previous][Next]
The hazard warning lights do not illuminate.
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
 
 
TECHNICAL DESCRIPTION (COMMENT)
If the hazard warning lights do not illuminate, the hazard warning light switch input circuit in hazard indicators assembly or the ETACS-ECU may have a problem.
 
 
TROUBLESHOOTING HINTS
  • The hazard indicators assembly may be defective
  • The ETACS-ECU may be defective
  • The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
 
 
DIAGNOSIS
STEP 1. Check that the turn-signal lights operate.
Check that the turn-signal lights illuminate normally.
Is the check result normal?
Go to Step 2.
Diagnose the headlights. Refer to Inspection Procedure 11 "None of the turn-signal lights illuminate ."
 
STEP 2. Using scan tool (M.U.T.-IIISE), check data list
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect Scan Tool (M.U.T.-IIISE) ."
(2) Check the signals from the hazard warning light.
  • Turn ON the hazard light switch.
 
Item No.Item nameNormal condition
265Hazard switchON
OK: Normal condition is displayed.
Is the check result normal?
Go to Step 3.
Troubleshoot the ETACS-ECU. Refer to Inspection Procedure 10 "The hazard warning light switch signal is not received" .
 
STEP 3. Retest the system
Check that the hazard warning lights illuminate normally.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.