[Previous][Next]
DTC C2272 Delta SAS signal fail
 
 
caution
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When the steering wheel sensor is replaced, calibrate the steering wheel sensor (Refer to ).
 
 
OPERATION
FCM/LDW/AHB-ECU communicates with the steering wheel sensor via the CAN bus lines.
 
 
DTC SET CONDITION
This DTC is set when the abnormality below is detected:
  • The ECU receives an invalid steering wheel angular velocity signal from the steering wheel sensor.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of the steering wheel sensor (column switch assembly)
  • Malfunction of the FCM/LDW/AHB-ECU
 
 
DIAGNOSIS
STEP 1. Check whether the steering wheel sensor is installed properly.
Is the check result normal?
Go to Step 2
Install the steering wheel sensor properly.
 
STEP 2. Check whether the DTC is set again.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn on the power supply mode of the electric motor switch.
(3) Erase the DTC.
(4) Turn off the power supply mode of the electric motor switch.
(5) Turn on the power supply mode of the electric motor switch.
(6) Check if DTC is set.
Is the DTC set?
Replace the steering wheel sensor (column switch assembly) (Refer to GROUP 54A - Column Switch ) and then go to Step 3.
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 3. Check whether the DTC is set again.
Check again if the DTC is set in the FCM/LDW/AHB-ECU.
(1) Erase the DTC.
(2) Turn off the power supply mode of the electric motor switch.
(3) Turn on the power supply mode of the electric motor switch.
(4) Check if DTC is set.
Is the DTC set?
Replace the FCM/LDW/AHB-ECU (Refer to ).
This diagnosis is complete.