[Previous][Next]
REMOVAL AND INSTALLATION
 
 
COLUMN SWITCH ASSEMBLY
caution
  • Before removing the steering wheel and driver's air bag module assembly, refer to GROUP 52B - Service Precautions and Driver's Air Bag Module and Clock Spring .
  • After the installation, perform a calibration for the ASC-ECU to learn the steering wheel sensor neutral point. (Refer to GROUP 35C - On-vehicle Service, Steering Wheel Sensor Calibration ).
Pre-removal and Post-installation Operation
  • Regenerative braking level selector (paddle type) Removal and Installation (Refer to GROUP 37 - Steering Column Shaft Assembly ).
  • Clock spring Removal and Installation (Refer to GROUP 52B - Driver's Air Bag Module and Clock Spring ).
Removal Steps
<<A>>>>A<<1.Steering column switch assembly
2.Turn signal light & lighting switch
3.Windshield wiper & windshield washer switch
4.Steering column switch (Integrated with steering wheel sensor)
 
 
REMOVAL SERVICE POINT
 
 
<<A>> STEERING COLUMN SWITCH ASSEMBLY REMOVAL
1. Using a pliers or similar tool, pinch and lift the band clump pin shown in the figure.
2. With the flat-tipped screwdriver inserted into the column shaft groove shown in the figure, lift the claw shown in Section A - A, and then remove the steering column switch assembly by pulling out the steering column switch assembly.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< STEERING COLUMN SWITCH ASSEMBLY INSTALLATION
1. Using a pliers or similar tool, pinch and lift the band clump pin shown in the figure.
2. Align the part "A" position in the figure with the steering lock side rib, and then insert the steering column switch assembly into the column shaft.
3. After mounting the steering column switch assembly by securely fitting the steering column switch assembly claw with the column shaft groove, release the band clump pin.