[Previous][Next]
DTC C1707 Implausible coding data
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the communication circuit is normal.
 
 
OPERATION
FCM/LDW/AHB-ECU receives the vehicle information stored in ETACS-ECU via CAN bus lines.
 
 
DTC SET CONDITION
This DTC is set when the abnormality below is detected:
  • A unfeasible coding data is received from ETACS-ECU.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of the CAN bus line
  • ETACS-ECU coding fails
  • Malfunction of the ETACS-ECU
  • Malfunction of the FCM/LDW/AHB-ECU
 
 
DIAGNOSIS
STEP 1. Scan tool (M.U.T.-IIISE) CAN bus diagnostics.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn on the power supply mode of the electric motor switch.
(3) Diagnose the CAN bus line.
(4) Turn off the power supply mode of the electric motor switch.
Is the check result normal?
Go to Step 2
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. ETACS-ECU coding data check.
Using the scan tool (M.U.T.-IIISE), check if there is the FCM type2, LDW Parameter status abnormality to the coding data stored in the ETACS-ECU (Refer to GROUP 00 - Coding Reference Table ).
Is the check result normal?
Go to Step 3
Go to Step 4
 
STEP 3. Check whether the DTC is set again.
Check again if the DTC is set in the FCM/LDW/AHB-ECU.
(1) Erase the DTC.
(2) Turn off the power supply mode of the electric motor switch.
(3) Turn on the power supply mode of the electric motor switch.
(4) Check if DTC is set.
Is the DTC set?
Replace the FCM/LDW/AHB-ECU (Refer to ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 4. Check whether the DTC is set again.
Check again if the DTC is set in the FCM/LDW/AHB-ECU.
(1) Erase the DTC.
(2) Turn off the power supply mode of the electric motor switch.
(3) Turn on the power supply mode of the electric motor switch.
(4) Check if DTC is set.
Is the DTC set?
Repair the coding data or replace ETACS-ECU (Refer to GROUP 54A - ETACS-ECU ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).