[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation Operation
Brake Electric Vacuum Pump Assembly Removal and Installation (Refer to GROUP 35A - Brake Electric Vacuum Pump ).
Removal
<<A>>>>A<<1.Engine mounting bracket
 
 
REMOVAL SERVICE POINT
 
 
<<A>> ENGINE MOUNTING BRACKET REMOVAL
cautionWhen you support the assembly (which consists of the engine, the generator, the front motor and the front transaxle), the weight of the assembly must not be taken by the oil pan only. Always use wooden blocks or pieces and then place the oil pan flange on them. Never put the oil pan directly on a floor as it will be deformed.
1. Place a cart below the assembly.
2. Raise the vehicle to take the weight of the assembly off the engine mounting bracket.
3. Remove the nuts and bolts securing the engine mounting bracket.
4. Remove the engine mounting bracket.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< ENGINE MOUNTING BRACKET INSTALLATION
cautionDo not remove small tapping screw.
Tighten the engine mounting bracket mounting bolts by the following procedure.
 
OrderBoltTightening torque
1stAApproximately 0 - 5.0 N·m (0 - 44 in-lb)
2ndB50 ± 5 N·m (37 ± 3 ft-lb)
3rdA50 ± 5 N·m (37 ± 3 ft-lb)