[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal steps
1.Main muffler
2.Exhaust center pipe
3.Seal ring
Floor console side cover (Refer to GROUP 52A - Front Floor Console Assembly ).
Turn up the driver’s side floor carpet
Heated oxygen sensor (rear) (Refer to ).
4.Exhaust front pipe
5.Seal ring
<<A>>>>A<<6.Rivet
7.Heat protector
 
 
REMOVAL SERVICE POINT

 
 
<<A>> RIVET REMOVAL
cautionBe careful not to damage the heat protector with the drill.
Use a drill [6.0 mm (0.24 inch)] to make a hole in the rivet to break it, and then remove the rivet.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< RIVET INSTALLATION
Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1. Insert the rivet into a corresponding location.
2. Set the rivet tool at a portion A of rivet.
3. While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4. Thin part of portion A of the rivet will be cut off and the parts is fixed in position.