[Previous][Next]
REMOVAL AND INSTALLATION <REAR>
 
 
Pre-removal and Post-installation Operation
  • Motor Coolant Draining and Refilling (Refer to ).
  • Cargo Floor Box Removal and Installation (Refer to GROUP 52A - Interior Trim ).
  • EV Motor Control Unit Cover, EV Control Unit Cover Removal and Installation (Refer to GROUP 54Dd - On Board Charger/DC-DC Converter ).
Removal steps
<<A>>>>A<<1.EV radiator pipe G
<<A>>>>A<<2.EV radiator piping hose S
3.Ground bolt
<<A>>>>A<<4.EV radiator pipe H
<<A>>>>A<<5.EV radiator piping hose N
<<A>>>>A<<6.EV radiator piping hose L
<<A>>>>A<<7.EV radiator pipe J
<<A>>>>A<<8.EV radiator piping hose Q
<<A>>>>A<<9.EV radiator piping hose P
 
 
REMOVAL SERVICE POINT
 
 
<<A>> EV RADIATOR CONDENSER TANK HOSE/EV RADIATOR PIPING HOSE REMOVAL
Make mating marks on the hose and the hose clip as shown to install them in the original position.
 

 

 
 
INSTALLATION SERVICE POINT
 
 
>>A<< EV RADIATOR PIPING HOSE/EV RADIATOR CONDENSER TANK HOSE CONNECTION
1. Insert the hose until the protrusion of the fitting or pipe.
2. Align the mating marks on the hose and hose clip.