[Previous][Next]
DTC C2200 ECU internal error
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
ASC-ECU controls ASC by calculating the data sent from the wheel speed sensor, the steering wheel sensor, and the G and yaw rate sensor.
 
 
 
DTC SET CONDITIONS
This DTC is set when ASC-ECU has malfunction.
 
 
 
TROUBLESHOOTING HINTS
ASC-ECU malfunction
 
 
 
 
DIAGNOSIS
Check whether the DTC is set again.
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Erase the DTC.
Is DTC No. C2200 set?
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ).
This diagnosis is complete.