[Previous][Next]
Inspection Procedure 17: The starter does not rotate at the "P" or "N" range. (The engine does not start.)
 
 
 
 
PROBABLE CAUSES
  • Engine system failure
  • Poor adjustment of transaxle control cable
  • Poor adjustment of transmission range switch
  • Failure of the transmission range switch main unit
  • The starter electric wiring
  • Damaged harness or connector
  • Malfunction of the TCM
 
 
DIAGNOSIS
STEP 1. Check the engine performance.
Is the check result normal?
Go to Step 2.
Repair the failure, and perform adjustment.
 
STEP 2. Check the transaxle control cable.
Check the installation of the transaxle control cable.
Is the check result normal?
Go to Step 3.
Adjust the transaxle control cable .
 
STEP 3. Check and adjust the transmission range switch.
Refer to .
If the transmission range switch has a failure, replace it, and then check the trouble symptom again.
Is the check result normal?
The procedure is complete.
Go to Step 4.
 
STEP 4. Check the electric system.
Check the starter-related wiring for poor insertion of connector or open circuit.
Is the check result normal?
Replace the TCM.
Repair the failure, and perform adjustment.