[Previous][Next]
DTC P0513: Immobilizer Malfunction
 
 
 
 
TECHNICAL DESCRIPTION
  • ECM monitors the communication condition with the immobilizer-ECU. When an abnormality in communication is found, ECM prevents engine start.
 
 
DTC SET CONDITIONS
Check Conditions
  • Ignition switch is "ON" position.
  • After the engine is cranked.
Judgment Criteria
  • When it was different in the encrypted code sent from immobilizer-ECU and operation result by ECM.
 
 
FAIL-SAFE AND BACKUP FUNCTION
  • Engine start is prohibited.
 
 
TROUBLESHOOTING HINTS (The most likely causes for this code to be stored are: )
  • Malfunction of CAN system.
  • Malfunction of immobilizer system.
  • ECM failed.

 
 
DIAGNOSIS
Required Special Tools:
  • MB992744: Vehicle Communication Interface-Lite (V.C.I.-Lite)
  • MB992745: V.C.I.-Lite Main Harness A
  • MB992747: V.C.I.-Lite USB Cable Short
  • MB991958: Scan Tool (M.U.T.-III Sub Assembly)
    • MB991824: Vehicles Communication Interface (V.C.I.)
    • MB991827: M.U.T.-III USB Cable
    • MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
STEP 1. Using scan tool (M.U.T.-III), check VIN Information.
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
(1) Connect scan tool (M.U.T.-III). Refer to HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) .
(2) Turn the ignition switch to the "ON" position
(3) Set scan tool (M.U.T.-III) to the coding mode for VIN Information.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Has VIN (current) been written?
Go to Step 2.
Write VIN. Then go to Step 2.
 
STEP 2. Using scan tool (M.U.T.-III), read the immobilizer diagnostic trouble code (DTC).
(1) Turn the ignition switch to the "ON" position.
(2) Read the OSS-DTC.
(3) Turn the ignition switch to the "LOCK" (OFF) position.
Is the immobilizer-DTC stored?
Refer to GROUP 42B, Diagnosis <OSS-ECU> - Diagnostic Trouble Code Chart .
Go to Step 3.
 
STEP 3. Using scan tool (M.U.T.-III), read the diagnostic trouble code (DTC)
(1) Turn the ignition switch to the "ON" position.
(2) After the DTC has been deleted, read the DTC again.
(3) Turn the ignition switch to the "LOCK" (OFF) position.
Is DTC P0513 stored?
Replace the ECM (Refer to Removal and Installation ).
It can be assumed that this malfunction is intermittent. Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions .