[Previous] [Next]

SENSOR CABLE INSTALLATION PROCEDURE


If there is a malfunction in the front wiring harness between the front impact sensor and body wiring harness, install and route a new sensor cable (Refer to .)



Wait at least 60 seconds after disconnecting the battery cable before doing any further work. (Refer to .)

Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
1.Disconnect the negative (-) battery cable and tape the terminal to prevent accidental connection and air bags deployment.

2.Make a cut in the grommet in the place shown in the illustration, and pass the sensor cable through the cut.

3.Run the sensor cable along the front wiring harness, and then secure the cable to the harness with insulation tape.
4.Apply the specified sealant inside the grommet.

5.Exchange the terminal of the front wiring harness connector C-17 (Female side connector) shown in the illustration with the terminal of the sensor cable shown in the illustration.



POST-INSTALLATION INSPECTION
1.Reconnect the negative (-) battery cable.
2.Turn the ignition key to the "ON" position.

3.Does the "SRS" warning light illuminate for approximately 7 seconds, and then remain off for at least 5 seconds after turning "OFF?"
4.If yes, SRS system is functioning properly. If no, refer to "SRS Diagnosis" on .