ASSEMBLY SERVICE POINTS ►A◄SOLENOID VALVE INSTALLATION 1.Apply ATF, petroleum jelly or Vaseline to O-ring, and install it to solenoid valves. 2.Following the marks made when removing, install each solenoid valve in its proper position.

►B◄DOWEL PIN INSTALLATION

Install the dowel pin at the specified position on the lower valve body.

►C◄KNOCK BUSHING INSTALLATION

Install the knock bushing onto the lower valve body position shown in the illustration.

►D◄KNOCK BUSHING INSTALLATION

Install the knock bushing onto the lower valve body position shown in the illustration.

►E◄SPRING/STEEL BALL (LINE RELIEF) INSTALLATION

Install the spring [7 mm (0.276 inch) diameter, 17.3 mm (0.681 inch) length] and the steel ball [6.4 mm (0.25 inch) diameter] onto the lower valve body position shown in the illustration.

►F◄SPRING/STEEL BALL (ORIFICE CHECK BALL)/BALL (ORIFICE CHECK BALL)/DAMPING VALVE SPRING/SEAL RING/DAMPING VALVE INSTALLATION

1.Install the spring [4.5 mm (0.177 inch) diameter, 15.4 mm (0.606 inch) length] and the steel ball [6.4 mm (0.25 inch) diameter] onto the upper valve body position shown in the illustration. 2.Install the ball (rubber) [6.4 mm (0.25 inch) diameter] onto the upper valve body position shown in the illustration. 3.After installing the seal ring onto the damping valve, install together with the damping valve spring [7.7 mm (0.303 inch) diameter, 35.8 mm (1.409 inch) length] onto the upper valve body position shown in the illustration.