DTC P0183: Fuel Tank Temperature Sensor Circuit High Input

CIRCUIT OPERATION
• 5-volt voltage is applied to the fuel tank temperature sensor output terminal (terminal No. 1) from the PCM (terminal No. 51) via the resistor in the PCM.
• The fuel tank temperature sensor output voltage increases when the resistance increases and decreases when the resistance decreases. The ground terminal (terminal No. 3) is grounded to the vehicle body.
TECHNICAL DESCRIPTION
• The fuel tank temperature sensor converts the fuel tank temperature to a voltage.
• The PCM detects the fuel tank temperature in the fuel tank with this output voltage.
DESCRIPTIONS OF MONITOR METHODS
Fuel tank temperature sensor output voltage is out of specified range.
MONITOR EXECUTION
Continuous
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
• Not applicable

Sensor (The sensor below is determined to be normal)
• Engine coolant temperature sensor
• Intake air temperature sensor
DTC SET CONDITIONS Logic Flow Chart


Check Conditions
2 seconds or more have passed since the starting sequence was completed.

Judgement Criteria
• Sensor output voltage has continued to be 4.6 volts or higher for 2 seconds.
OBD-II DRIVE CYCLE PATTERN
Refer to Diagnostic Function - OBD-II Drive Cycle - Procedure 6 - Other Monitor .
TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:
• Fuel tank temperature sensor failed.
• Open fuel tank temperature sensor circuit, harness damage or connector damage.
• PCM failed.
NOTE: A diagnostic trouble code (DTC) could be output if the engine coolant is changed as indicated below. Because this is not a failure, the DTC must be erased.
Make sure to test drive the vehicle in accordance with the drive cycle pattern in order to verify that a DTC will not be output.
• The engine and the radiator have been flushed repeatedly when the engine coolant temperature was high (or the fuel tank temperature was high).