DTC P0175: System too Rich (bank 1)

Fuel Trim Circuit
• Refer to DTC P0201 - P0206, Injector Circuit.

CIRCUIT OPERATION
• Refer to DTC P0201 - P0206, Injector Circuit.
TECHNICAL DESCRIPTION
• If a malfunction occurs in the fuel system, the fuel trim value becomes too small.
• The PCM checks whether the fuel trim value is within a specified range.
DESCRIPTIONS OF MONITOR METHODS
Left bank air/fuel learning value (long term fuel trim) and air/fuel feedback integral value (short term fuel trim) are too rich.
MONITOR EXECUTION
Continuous
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
• Misfire monitor

Sensor (The sensor below is determined to be normal)
• Volume airflow sensor
• Engine coolant temperature sensor
• Intake air temperature sensor
• Barometric pressure sensor
• Throttle position sensor
DTC SET CONDITIONS Logic Flow Chart


Check Conditions
Under the closed loop air/fuel ratio control.
Engine coolant temperature is higher than 77°C (171°F).
Volume airflow sensor output frequency is 100 Hz or more.

Judgment Criteria
• Long-term fuel trim has continued to be lower than -12.5 percent for 5 seconds.
or
• Short-term fuel trim has continued to be lower than -7.4 percent for 5 seconds.

Check Conditions
• Under the closed loop air/fuel ratio control.
• Engine coolant temperature is higher than 77°C (171°F).
• Volume airflow sensor output frequency is 100 Hz or less.

Judgment Criteria
• Long-term fuel trim has continued to be lower than -12.5 percent for 5 seconds.
or
• Short-term fuel trim has continued to be lower than -12.5 percent for 5 seconds.

Check Conditions
• Engine coolant temperature is higher than 77°C (171°F).
• Under the closed loop air/fuel ratio control.

Judgment Criteria
• Long-term fuel trim has continued to be -12.5 percent for 5 seconds.
or
• Short-term fuel trim has continued to be -30.0 percent for 5 seconds.
OBD-II DRIVE CYCLE PATTERN
Refer to Diagnostic Function - OBD-II Drive Cycle - Procedure 2 - Fuel Trim Monitor .

TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:
• Volume airflow sensor failed.
• Injector (Number 2, 4, 6) failed.
• Incorrect fuel pressure.
• Engine coolant temperature sensor failed.
• Intake air temperature sensor failed.
• Barometric pressure sensor failed.
• Connector damage.
• PCM failed.