[Previous][Next]
PRINTED HEATER CHECK
1. Let the engine run (2,000 r/min), and check the printed heater with the battery fully charged.
2. With the rear window defogger switch "ON," use the circuit tester to measure the voltage of each printed heater at the rear window glass center A point. If approximately 6 V is indicated, it is judged good.
3. If the voltage of 12 V is indicated at the A point, there is an open circuit between the A point and negative terminal. Therefore, by moving the test bar slowly to the negative side, search and determine the location where the voltage changes suddenly (0 V). The location of voltage change indicates the open circuit position.
4. Also, if the voltage indicates 0 V at the A point, there is an open circuit between the A point and positive terminal. Therefore, search and determine the location of voltage change (12 V) using the above mentioned method.
5. If a malfunction such as open circuit occurs, replace the liftgate window glass (Refer to GROUP 42A - Liftgate Window Glass ).