[Previous][Next]
DIAGNOSTIC TROUBLE CODE CHART
caution
  • During diagnosis, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTC(s). If DTC(s) are set, erase them all.
  • If the combination meter needs to be replaced as a result of troubleshooting, the current driving distance and elapsed days must be entered into the meter after the replacement in order to be used for service reminder function. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current schedule" from the meter before the replacement using the special function of scan tool (M.U.T.-IIISE), and note them. For the operation method of scan tool (M.U.T.-IIISE), refer to . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read from the meter using scan tool (M.U.T.-IIISE), use the following method.
    1. As for the driving distance for check warning, use the driving distance displayed on the multi information display.
    2. As for the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service reminder function start date) and current date.
DTC No.Diagnostic itemReference page
B1201Fuel information problem
B2463Rheostat switch sticking
B2464Meter information SW sticking
U0100Engine CAN timeout
U0141ETACS CAN timeout
U0159CAMERA CAN timeout <Vehicles with multi around monitor>
U0164A/C CAN timeout
U0245NAVI/DISP AUDIO CAN timeout <Vehicles with Smartphone Link Display Audio>
U1000OSS/KOS_OSS CAN timeout <Vehicles with KOS>
U1190No receive fault detect signal
U1195Coding not completed