[Previous][Next]
REMOVAL AND INSTALLATION
Post-installation Operation
  • Check the Dust Cover for Cracks or Damage by Pushing it with your finger.
Stabilizer link removal steps
<<A>>>>C<<1.Stabilizer link and stabilizer bar connection nut
<<B>>>>D<<2.Stabilizer link and strut connection nut
3.Stabilizer link
Stabilizer bushing removal steps
4.Stabilizer bar bracket
>>B<<5.Stabilizer bushing
Stabilizer bar removal steps
<<A>>>>C<<1.Stabilizer link and stabilizer bar connection nut
4.Stabilizer bar bracket
>>B<<5.Stabilizer bushing
Engine room under cover front B (Refer to GROUP 51 - Under Cover ) <AWD>
Engine roll stopper rod (Refer to GROUP 32 - Engine Roll Stopper Rod ) <AWD>
Dynamic damper (Refer to GROUP 23A - Transfer Assembly ) <AWD>
Front floor backbone brace (Refer to GROUP 42A - Loose Panel )
Exhaust center pipe and exhaust front pipe disconnection (Refer to GROUP 15 - Exhaust Pipe, Main Muffler and Catalytic Converter )
<<C>>>>A<<6.Stabilizer bar
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> STABILIZER LINK AND STABILIZER BAR CONNECTION NUT REMOVAL
Use a hexagon wrench to counterhold the stabilizer link as shown. Then use a wrench to remove the nut securing the stabilizer link to the stabilizer bar.
 
 
 
<<B>> STABILIZER LINK AND STRUT CONNECTION NUT REMOVAL
Use a hexagon wrench to counterhold the stabilizer link as shown. Then use a wrench to remove the nut securing the stabilizer link to the strut.
 
 
 
<<C>> STABILIZER BAR REMOVAL
Remove the stabilizer bar from the right side of the vehicle as shown.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< STABILIZER BAR INSTALLATION
Install the stabilizer bar from the right side of the vehicle as shown.
 
 
 
>>B<< STABILIZER BUSHING INSTALLATION
Install the stabilizer bushing as shown in the figure.
 
 
 
>>C<< STABILIZER LINK AND STABILIZER BAR CONNECTION NUT INSTALLATION
Use a hexagon wrench to counterhold the stabilizer link as shown. Then use a wrench to install the nut securing the stabilizer link to the stabilizer bar.
 
 
 
>>D<< STABILIZER LINK AND STRUT CONNECTION NUT INSTALLATION
Use a hexagon wrench to counterhold the stabilizer link as shown. Then use a wrench to install the nut securing the stabilizer link to the strut.