[Previous][Next]
DTC U1426: ASC Data Malfunction
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
AWC-ECU communicates with ASC-ECU via the CAN bus lines.
 
 
DTC SET CONDITIONS
The DTC is set when abnormality is detected in the brake pressure signal received from the ASC-ECU.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • Malfunction of ASC-ECU
  • Malfunction of AWC-ECU

 
 
DIAGNOSIS
STEP 1. Scan tool (M.U.T.-IIISE) CAN bus diagnostics.
Use scan tool (M.U.T.-IIISE) to perform the CAN bus diagnosis.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Diagnosis, Can Bus Diagnostics Table ).
 
STEP 2. Scan tool (M.U.T.-IIISE) other system DTC.
Check the ASC DTC (Refer to GROUP 35C - Diagnosis, Diagnostic Trouble Code Chart ).
Is the DTC set?
Perform the relevant troubleshooting.
Go to Step 3.
 
STEP 3. Check whether the DTC is set again.
Is the DTC U1426 set?
Replace the AWC-ECU (Refer to ). Then go to Step 4.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
 
STEP 4. Check whether the DTC is set again
Is the DTC U1426 set?
Replace the ASC-ECU (Refer to GROUP 35C - Hydraulic Unit ).
This diagnosis is complete.