[Previous][Next]
REMOVAL AND INSTALLATION
 
 
caution
  • Before removing the steering wheel and driver’s air bag module assembly, refer to GROUP 52B - Service Precautions and Driver’s Air Bag Module and Clock Spring .
  • After the steering column switch assembly (integrated with steering wheel sensor) is installed, always calibrate the steering wheel sensor. (Refer to GROUP 35C - On-vehicle Service, Sensor Calibration ).
Steering Column Switch Assembly Removal Steps
Steering wheel assembly (Refer to GROUP 37 - Steering .)
Steering column cover lower and steering column cover upper (Refer to GROUP 52A - Instrument Panel Assembly .)
Clock spring (Refer to GROUP 52B - Driver’s Air Bag Module and Clock Spring .)
<<A>>>>A<<1.Steering column switch assembly
2.Turn signal light & lighting switch
3.Windshield wiper & windshield washer switch
4.Steering column switch (Integrated with steering wheel sensor)
Turn Signal Light & Lighting Switch Removal Steps
Steering column cover upper (Refer to GROUP 52A - Instrument Panel Assembly .)
2.Turn signal light & lighting switch
Windshield Wiper & Windshield Washer Switch Removal Steps
Steering column cover upper (Refer to GROUP 52A - Instrument Panel Assembly .)
3.Windshield wiper & windshield washer switch
 
 
REMOVAL SERVICE POINT
 
 
<<A>> STEERING COLUMN SWITCH ASSEMBLY REMOVAL
1. Using a pliers or similar tool, pinch and lift the band clump pin shown in the figure.
2. With the flat-tipped screwdriver inserted into the column shaft groove shown in the figure, lift the claw shown in Section A - A, and then remove the steering column switch assembly by pulling out the steering column switch assembly.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< STEERING COLUMN SWITCH ASSEMBLY INSTALLATION
1. Using a pliers or similar tool, pinch and lift the band clump pin shown in the figure.
2. Align the part "A" position in the figure with the steering lock side rib, and then insert the steering column switch assembly into the column shaft.
3. After mounting the steering column switch assembly by securely fitting the steering column switch assembly claw with the column shaft groove, release the band clump pin.