[Previous][Next]
DTC U1195: Coding Not Completed
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When diagnostic trouble code No.U1195 is set in AWC-ECU, the diagnostic trouble code may also be set in ETACS-ECU. When the diagnostic trouble code is set in ETACS-ECU, perform the diagnosis of the diagnostic trouble code for ETACS-ECU first.
 
 
OPERATION
AWC-ECU receives the vehicle information stored in ETACS-ECU via CAN bus lines.
 
 
DTC SET CONDITIONS
The DTC is set when the AWC-ECU coding has not been performed.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • A variant coding for the ETACS-ECU has not been implemented.
  • Malfunction of ETACS-ECU
  • Malfunction of AWC-ECU
 
 
DIAGNOSIS
STEP 1. Scan tool (M.U.T.-IIISE) CAN bus diagnostics.
Use scan tool (M.U.T.-IIISE) to perform the CAN bus diagnosis.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Diagnosis, Can Bus Diagnostics Table ).
 
STEP 2. Scan tool (M.U.T.-IIISE) other system DTC.
Check the ETACS DTC (Refer to GROUP 54A - Diagnosis, Diagnostic Trouble Code Chart ).
Is the DTC set?
Perform the relevant troubleshooting.
Go to Step 3.
 
STEP 3. ETACS-ECU coding data check
Using the scan tool (M.U.T.-IIISE), check if there is any abnormality to the coding data stored in the ETACS-ECU.
Is the check result normal?
Go to Step 4.
Replace the ETACS-ECU (Refer to GROUP 54A - ETACS-ECU ).
 
STEP 4. Check whether the DTC is set again.
Is the DTC U1195 set?
Replace the AWC-ECU (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).