[Previous][Next]
DTC C2350: Received FCM temporary fail from FCM/LDW/AHB ECU
 
 
caution
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When the ACC/FCM-ECU is replaced, calibrate the radar (refer to ).
 
 
OPERATION
ACC/FCM-ECU communicates with the FCM/LDW/AHB-ECU via the CAN bus lines.
 
 
DIAGNOSTIC TROUBLE CODE SET CONDITION
Check Conditions
  • More than 5 seconds have passed since the ignition switch was turned to "ON" position.
  • ACC/FCM-ECU power voltage is more than 9 volts and is less than 18 volts.
Judgment Criterion
  • A signal, which indicates a temporary failure the FCM system, is received from the FCM/LDW/AHB-ECU.
noteA DTC is not set as a historic fault.
 
 
PROBABLE CAUSES
  • Defective of the FCM/LDW/AHB system (FCM control related)
  • Temporary failure of the ACC/FCM-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-IIISE), check the FCM/LDW/AHB-ECU DTC.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn the ignition switch to the "ON" position.
(3) Using scan tool (M.U.T.-IIISE), check the FCM/LDW/AHB-ECU DTC (Refer to GROUP 54A - FCM/LDW/AHB-ECU, Diagnosis, Diagnostic Function ).
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the DTC set?
Perform the relevant troubleshooting (Refer to GROUP 54A - FCM/LDW/AHB-ECU ).
Go to Step 2.
 
STEP 2. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Is the DTC C2350 set?
Replace the ACC/FCM-ECU (Refer to ).
It can be assumed that this malfunction is intermittent (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunction ).