DTC P0507: Idle Control System RPM Higher Than Expected

CIRCUIT OPERATION
• The idle air control motor power is supplied from the MFI relay (terminal No. 4).
• The ECM (terminals No. 4, No. 5, No. 17, No. 18) <M/T> or PCM (terminals No. 14, No. 15, No. 28, No. 29) <A/T> drives the stepper motor by sequentially turning "ON" the power transistors in the ECM <M/T> or PCM <A/T> and providing ground to the idle air control motor (terminals No. 1, No. 3, No. 4, No. 6).
TECHNICAL DESCRIPTION
• The amount of air taken in during idling is regulated by the opening and closing of the servo valve located in the air passage that bypasses the throttle body.
• If there is a malfunction of the IAC system, the actual engine speed will not be identical to the target engine speed.
• The ECM <M/T> or PCM <A/T> checks the difference between the actual engine speed and the target engine speed.
DESCRIPTIONS OF MONITOR METHODS
• If the actual engine speed is higher by a prescribed value than the target idle speed, a malfunction is determined to have occurred.
MONITOR EXECUTION
Continuous
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
• Misfire monitor
• EGR system monitor
• Fuel system monitor

Sensor (The sensor below is determined to be normal)
• Volume airflow sensor
• Barometric pressure sensor
• Intake air temperature sensor
• Engine coolant temperature sensor
• Throttle position sensor
DTC SET CONDITIONS Logic Flow Chart


Check Conditions
Vehicle speed has reached 1.5 km/h (0.93 mph) or more at least once.
Under the closed loop idle speed control.
Engine coolant temperature is higher than 77°C (171°F).
Battery positive voltage is higher than 10 volts.
Barometric pressure is higher than 76 kPa (22.4 in.Hg).
Intake air temperature is higher than -10°C (14°F).
25 seconds have elapsed from the start of the previous monitoring.
Target idle air control motor position is 0 steps.

Judgment Criterion
Actual idle speed has continued to be higher than the target idle speed by 200 r/min (300 r/min*) or more for 12 seconds.
*: Specs in parentheses are applicable if the maximum air temperature during the previous operation was more than 45°C (113°F).
OBD-II DRIVE CYCLE PATTERN
Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 17 .
TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:
• Idle air control motor failed.
• Open or shorted idle air control motor circuit, or connector damage.
• ECM failed. <M/T>
• PCM failed. <A/T>