[Previous][Next]
REMOVAL AND INSTALLATION
 
 
caution
  • Disconnect the battery (-) terminal and wait for 60 seconds or more before starting work. Insulate the disconnected (-) terminal by wrapping a tape.
  • Handle the front impact sensor with sufficient caution, and do not drop the sensor or allow contact with water, oil, or others. If a dent, crack, deformation and others are discovered, replace it with a new one.
Headlight support panel upper removal steps
•Front bumper assembly (Refer to GROUP 51, Front Bumper Assembly and Radiator Grille .)
•Hood latch, hood lock release cable (front side) and damper (Refer to GROUP 42A, Hood .)
•Front impact sensor (Refer to GROUP 52B, Front Impact Sensor .)
1.Headlight support panel upper
•Headlight assembly (Refer to GROUP 54A, Headlight .)
2.Headlight support bracket
Air guide side panel removal
•Front bumper assembly (Refer to GROUP 51, Front Bumper Assembly and Radiator Grille .)
3.Air guide side panel
Rear seatback bracket removal steps
•Rear seatback assembly (Refer to GROUP 52A, Rear Seat Assembly .)
4.Rear seatback bracket