35C-DTC C1364 INTERNAL MALFUNCTION OF PRESSURE SENSOR

Code No. C1361 M/C pressure SNSR.stuck/low gain
Code No. C1364 M/C pressure SNSR.malfunction

caution

If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C, CAN Bus Diagnostics Table ).
Whenever ECU is replaced, ensure that the CAN bus lines are normal.
When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor and the G and yaw rate sensor (Refer to and ).

OPERATION

ASC-ECU incorporates the pressure sensor, and monitors the brake fluid pressure.

DIAGNOSTIC TROUBLE CODE SET CONDITIONS

This diagnostic trouble code will be set under the cases below:

Pressure sensor power supply voltage malfunction.
Pressure sensor signal malfunction.
Abnormal result of initial check performed when the power is supplied to ASC-ECU.

PROBABLE CAUSES