[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal steps
1.Self-locking nut
2.Exhaust tail pipe
3.Seal ring
4.Main muffler
5.Seal ring
6.Heat protector panel dash upper
Gearshift cable and select cable assembly (Refer to GROUP 22A - Transmission Control ) <M/T>.
Transmission control cable (Refer to GROUP 23A - Transmission Control ) <CVT>.
7.Heat protector panel front floor front
8.Heat protector panel front floor rear
9.Heat protector panel rear
>>A<<10.Damper hanger
11.Hanger
Required Special Tool:
  • MB991953: Oxygen Sensor Wrench
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< DAMPER HANGER INSTALLATION
Install the damper hanger in the direction shown in the figure.