[Previous][Next]
DTC P0604: Internal Control Module Random Access Memory (RAM) Error
 
 
 
 
TECHNICAL DESCRIPTION
Monitors the computation function of the ECM periodically.
 
 
DTC SET CONDITIONS
Check Condition
  • Ignition switch is "ON" position.
Judgment Criterion
  • All RAM data of ECM are defect.
or
  • RAM data (engine) is defect.
 
 
FAIL-SAFE AND BACKUP FUNCTION
  • Microcomputer is reset.
or
  • Throttle opening degree position is in default position.
 
 
TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:)
  • ECM failed.
 
 
 
DIAGNOSIS
Required Special Tools:
  • MB992744: Vehicle communication interface-Lite (V.C.I.-Lite)
  • MB992745: V.C.I.-Lite main harness A
  • MB992747: V.C.I.-Lite USB cable short
  • MB992748: V.C.I.-Lite USB cable long
  • MB991958: Scan Tool (M.U.T.-III Sub Assembly)
    • MB991824: Vehicles Communication Interface (V.C.I.)
    • MB991827: M.U.T.-III USB Cable
    • MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
STEP 1. Using scan tool (M.U.T.-III), read the diagnostic trouble code (DTC).
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
(1) Connect scan tool (M.U.T.-III). Refer to HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) .
(2) Turn the ignition switch to the "ON" position.
(3) After the DTC has been deleted, read the DTC again.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is DTC P0602 set?
Replace the ECM with one into which vehicle information is correctly entered (Refer to, Removal and Installation ).
It can be assumed that this malfunction is intermittent. Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions .