[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation Operation
  • Removal and Installation of Front Pillar Trim, Upper center Pillar Trim, Rear Pillar Trim (Refer to ).
  • Removal and Installation of Rear Seatbelt Outer Assembly (RH or LH) (Refer to ).
  • Removal and Installation of Dome Light Assembly (Refer to GROUP 54A, Dome Light ).
  • Removal and Installation of Passenger's Air Bag Cut OFF Indicator Light Assembly (Refer to GROUP 52B, Passenger's Air Bag ON/OFF Indicator Light ).
Removal steps
1.Assist grip
2.Sun visor assembly
<<A>>3.Sun visor holder
<<B>>4.Headlining
5.Assist grip bracket
6.Headlining pad
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> SUN VISOR HOLDER REMOVAL
Insert the special tools ornament remover (MB990784) into the sun visor holder from its left and right sides to disengage the claws on the sun visor holder sides.
 

 
 
<<B>> HEADLINING REMOVAL
To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.