[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Turn the ignition switch to the LOCK (OFF) position.
Removal steps
<<A>>1.Negative (-) battery cable
2.Passenger's air bag OFF indicator light assembly
3.Passenger's air bag OFF indicator light
4.Cover
Installation steps
>>A<<•Pre-installation inspection
4.Cover
3.Passenger's air bag OFF indicator light
2.Passenger's air bag OFF indicator light assembly
1.Negative (-) battery cable
>>B<<•Post-installation inspection
 
 
REMOVAL SERVICE POINT
 
 
<<A>> NEGATIVE (-) BATTERY CABLE DISCONNECTION
dangerWait at least 60 seconds after disconnecting the battery cable before doing any further work (Refer to ).
warningBattery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< PRE-INSTALLATION INSPECTION
Check the passenger’s air bag OFF indicator light for dents, breakage and bending and measure the resistance between the terminals, even when installing a new passenger’s air bag OFF indicator light.

 
 
>>B<< POST-INSTALLATION INSPECTION
1. Turn the ignition switch to the "ON" position.
2. Check that the SRS warning light is illuminated for 6 to 8 seconds, and extinguished afterward.
3. If the light does not extinguish, perform the troubleshooting (Refer to ).
4. Check that the passenger’s air bag OFF indicator light is illuminated for 6 to 8 seconds, and extinguished afterward.
5. If the light does not extinguish, perform the troubleshooting (Refer to ).