REMOVAL AND INSTALLATION
Post-installation Operation
Liftgate Alignment (Refer to
).
Liftgate latch removal steps
•
Liftgate trim (Refer to GROUP 52A - Liftgate Trims
)
•
Rear wiper motor assembly (Refer to GROUP 51 - Rear Wiper and Washer
)
1.
Liftgate latch assembly
2.
Liftgate lock rod
3.
Liftgate open rod
Lock key cylinder <Vehicles without keyless entry system> removal steps
•
Liftgate trim (Refer to GROUP 52A - Liftgate Trims
)
•
Rear wiper motor assembly (Refer to GROUP 51 - Rear Wiper and Washer
)
4.
Retainer
5.
Lock key cylinder
Liftgate lock release handle removal steps
•
Liftgate trim (Refer to GROUP 52A - Liftgate Trims
)
•
Rear wiper motor assembly (Refer to GROUP 51 - Rear Wiper and Washer
)
6.
Liftgate lock release handle
Striker removal
>>A<<
7.
Striker
Pull handle removal
8.
Pull handle
INSTALLATION SERVICE POINT
>>A<< STRIKER INSTALLATION
Install the striker so that the striker center does not deviate more than ±1.5 mm (0.06 inches) from the latch center.
).![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)