[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Engine Coolant Draining (Refer to ).
  • Drive Belt Removal (Refer to GROUP 11A - Crankshaft Pulley ).
Post installation Operation
  • Drive Belt Installation (Refer to GROUP 11A - Crankshaft Pulley ).
  • Engine Coolant Refilling (Refer to ).
Removal steps
<<A>>1.Water pump pulley
>>A<<2.Water pump
>>A<<3.O-ring
 
 
REMOVAL SERVICE POINT
 
 
<<A>> WATER PUMP PULLEY REMOVAL
caution
  • Do not use the drive belt set up on the vehicles.
  • Do not use a cracked or damaged drive belt.
Use the used drive belt to fix the water pump pulley, and remove the water pump pulley mounting bolts.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< O-RING/WATER PUMP INSTALLATION
1. Carefully remove the drying material and other foreign materials on the installation groove for the water pump O-ring.
2. Carefully remove the drying material and other foreign materials on the water pump installation area of the timing chain case assembly.
3. Sufficiently apply water or coolant to the O-ring to prevent it from dropping using brushes.
4. Securely fit the O-ring flange area into the installation groove of the water pump O-ring.
5. Reverse the water pump carefully and check that the O-ring does not fall down.
6.
cautionWhen installing the water pump, pay attention not to let the O-ring fall down or be bitten. Otherwise, a coolant leak may be caused.
Install the water pump to the timing chain case assembly.