Inspection Procedure

[Previous]

[Next]

Inspection Procedure

Perform action test to verify the customer's concern.
Perform action test and check the system operation after system diagnosis.

warning

Be careful of traffic conditions and safety around the vehicle when performing road test.

caution

Fully understand the following items well before the road test;
- System description: System Description.
- Handling precaution: Handling Precaution

1.CHECK LDW SYSTEM SETTING

Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
Check that the LDW system setting can be enabled/disabled on the information display.
Turn the electric motor switch OFF and wait for 30 seconds or more.
Check that the previous setting is saved when the engine starts again.

:

.

2.ACTION TEST FOR LDW

Enable the setting of the LDW system on the information display.
Turn LDW system ON.

Check the LDW operation according to the following table.

Condition				Action	Display on information display	Steering vibration
LDW OFF				—		OFF
LDW ON	Vehicle speed is less than approx. 60 km/h (37 MPH)			—	LDW system indicator : White Speaker icon : White	OFF
	Vehicle speed is approx. 60 km/h (37 MPH) or more	Vehicle closes to lane marker	Turn signal is OFF or ON (Opposite to the deviate side)	—	Yellow (Blink)	ON
			Turn signal is OFF or ON (Opposite to the deviate side)	—	LDW system indicator : Yellow (Blink) Speaker icon : White	ON
			Turn signal is ON(Deviate side)	—	LDW system indicator : White Speaker icon : White	OFF

note	After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 60 km/h (37 MPH). Refer to System Description.

: INSPECTION END