[Previous][Next]
System Description
 
 
SYSTEM DIAGRAM
ComponentDescription
ABS actuator and electric unit (control unit)ABS Actuator and Electric Unit (Control Unit)
BCMSystem Description
Front camera unitFront Camera Unit
ADAS control unit 2ADAS Control Unit 2
Combination meterCombination Meter
Steering vibration motorSteering Vibration Motor
 
 
ADAS CONTROL UNIT 2 INPUT/OUTPUT SIGNAL ITEM
 
 
Input Signal Item
Transmit unitSignal nameDescription
ABS actuator and electric unit (control unit)CAN communicationVehicle speed signal (ABS)Receives wheel speeds of four wheels
BCMCAN communicationTurn indicator signalReceives an operational state of the turn signal light and the hazard light
Combination meterCAN communicationSystem selection signalReceives a selection state of each item selected with the information display
Front camera unitCAN communicationDetected lane condition signalReceives detection results of lane marker
 
 
Output Signal Item
Reception unitSignal nameDescription
Combination meterCAN communicationMeter display signalTransmits a meter display signal to turn ON the LDW system display
Steering vibration motorMotor operation signalActivates a motor operation signal to active the steering vibration motor
 
 
FUNCTION DESCRIPTION
  • Lane Departure Warning (LDW) system provides a LDW function when the vehicle is driven at speeds of approximately 60 km/h (37 MPH) or more.
  • When the vehicle approaches either the left or the right side of the traveling lane, a steering vibration activates and the LDW indicator (yellow) on the combination meter blinks to alert the driver.
  • The warning does not occur during turn signal operation (Lane change side).
  • The warning function stops when the vehicle returns inside of the lane markers.
 
 
EXAMPLE
When the vehicle approaches the right lane marker, the driver is alerted by the steering vibration and the blinking of LDW warning display (yellow).
 
 
OPERATION DESCRIPTION
  • The front camera unit monitors lane markers of the traveling lane.
  • When judging from a lane marker detection signal that the vehicle is approaching the lane marker, the ADAS control unit 2 controls the following item to alert the driver.
    • Activates the steering vibration motor by ADAS control unit 2.
    • ADAS control unit 2 transmits a meter display signal to combination meter via CAN communication and turns ON/OFF the LDW system display.
 
 
OPERATION CONDITION
ADAS control unit 2 performs the control when the following conditions are satisfied.
  • LDW system: ON
  • Vehicle speed: approximately 60 km/h (37 MPH) or more
  • Turn indicator signal: After 2 seconds or more from turned OFF
note
  • LDW system ON/OFF can be set on the information display.
  • The LDW system may not function properly, depending on the situation. Refer to Handling Precaution.
 
 
CANCEL CONDITION
The ADAS control unit 2 cancels the operation when the system is under any conditions of the operation cancellation condition.
  • When the system malfunction occurs.
  • When the front camera unit becomes high temperature [over approximately 40 °C (104 °F)].