[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1F05 54 Front camera unit
(Front camera unit)
Diagnosis condition
  • When FCM system is ON
  • When driving the vehicle
Signal (terminal)
Threshold Camera aiming is not completed
Diagnosis delay time 10 seconds or more
 
 
POSSIBLE CAUSE
  • Front camera unit aiming is not adjusted
  • Front camera unit aiming adjustment has been interrupted
 
 
FAIL-SAFE
The following systems are canceled.
  • Vehicle-to-vehicle distance control mode
  • Conventional (fixed speed) cruise control mode
  • Steering wheel assistance function
  • FCM
  • LDW
  • LDP
  • Active Blind Spot Assist [ABSA]
  • TSR
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Drive the vehicle at 5 km/h (3 MPH) or more.
    cautionAlways drive safely.
  3. Perform “Read All DTCs” with M.U.T.-III SE.
  4. Check if the “C1F05-54” is detected as the current malfunction in "Diagnostic Trouble Code" of “ICC/ADAS 2”.
Is “C1F05-54” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure.
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END