[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1F04 48 FCM OPE COUNT LIMIT
Forward Collision Mitigation system count limit)
Diagnosis condition READY indicator: ON
Signal (terminal)
Threshold FCM system operated 3 times within electric motor switch is ON.
Diagnosis delay time 1 second or less
noteIf “C1F04-48” detected, perform the FCM system action test and FCM system operates normally.
 
 
POSSIBLE CAUSE
FCM system operated 3 times within electric motor switch is ON.
 
 
FAIL-SAFE
The following systems are canceled.
  • FCM
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “C1F04-48” is detected as the current malfunction in "Diagnostic Trouble Code" of “ICC/ADAS 2”.
Is “C1F04-48” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure.
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END