Diagnosis Procedure
1.
CHECK BSW INDICATOR CIRCUIT RH (FOR SHORT)
Turn the electric motor switch OFF.
Disconnect side radar RH harness connector and door mirror (driver side) harness connector.
Check continuity between side radar RH harness connector and ground.
Side radar RH
Ground
Continuity
Connector
Terminal
B462
6
Not existed
Is the inspection result normal?
.
Repair the harnesses or connectors.
2.
REPLACE THE DOOR MIRROR (DRIVER SIDE)
Replace the door mirror (driver side). Refer to
Removal and Installation
.
Erase in "Diagnostic Trouble Code" of “Side radar (Rear right)” with M.U.T.-III SE.
Perform “Read All DTCs” with M.U.T.-III SE.
Check if the “U1B46-11” is detected in "Diagnostic Trouble Code" of “Side radar (Rear right)”
Is the DTC “U1B46-11” detected?
Replace the side radar RH. Refer to
Removal and Installation
.
INSPECTION END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
. 
Repair the harnesses or connectors. . Replace the side radar RH. Refer to Removal and Installation. INSPECTION END