[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2A1F-16Camera power supply
(Camera power supply)
Diagnosis conditionWhen electric motor switch is ON
Signal (terminal)Camera power supply
Threshold0 V
Diagnosis delay time30 seconds or more
 
 
POSSIBLE CAUSE
  • LVDS cable (between around view monitor control unit and each camera)
  • Around view monitor control unit
 
 
FAIL-SAFE
  • Camera image not displayed
  • MOD (Moving Object Detection) function is stopped.
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn the electric motor switch ON.
  2. Turn the electric motor switch OFF and wait for at least 30 seconds.
  3. Turn the electric motor switch ON and wait at least 1 minute or more.
  4. Select "Diagnostic Trouble Code" mode of “Multi Around Monitor” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2A1F-16 detected?
Proceed to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END