[Previous][Next]
Component Function Check
1.PERFORM COMPONENT FUNCTION CHECK (1)
  1. Turn the electric motor switch OFF.
  2. Disconnect fuel level sensor unit and fuel pump connector.
  3. Connect variable resistor between harness connector terminals located on the vehicle side of the fuel level sensor unit.
    Fuel level sensor unit and fuel pump
    ConnectorTerminals
    B1021
  4. Set variable resistor according to the resistance value shown in the following table and turn the electric motor switch ON.
    Resistance (Ω)*
    (Approx.)
    		Fuel gauge indication position
    (Approx.)
    Less than 94.5Full
    1403/4
    1861/2
    2321/4
    2551/8
    More than 278Empty
    *: Reference resistance values used when the combination meter judges the indication position of the fuel gauge.
Is the inspection result normal?
Refer to Diagnosis ProcedureDiagnosis Procedure.
 
2.PERFORM COMPONENT FUNCTION CHECK (2)
Check the fuel level sensor unit and fuel pump. Refer to Component Inspection.
Is the inspection result normal?
INSPECTION END
Replace the fuel level sensor unit and fuel pump. Refer to FUEL PUMP MODULE DISASSEMBLY AND ASSEMBLY.