[Previous][Next]
Diagnosis Procedure (Without automatic drive positioner system)
1.CHECK POWER WINDOW MAIN SWITCH CIRCUIT
  1. Electric motor switch OFF.
  2. Disconnect power window main switch connector and door mirror connector.
  3. Check continuity between power window main switch harness connector and door mirror harness connector.
    Power window main switchDoor mirrorContinuity
    ConnectorTerminalConnectorTerminal
    D66Door mirror LHD1614Existed
    105
    173
    1811
    216
    7Door mirror RHD1066
    814
    95
    1911
    203
  4. Check continuity between power window main switch harness connector and ground.
    Power window main switch—Continuity
    ConnectorTerminal
    D67GroundNot existed
    8
    9
    19
    20
    6
    10
    17
    18
    21
Is the inspection result normal?
.
Repair or replace harness.
 
2.REPLACE DOOR MIRROR
Replace door mirror. Refer to Removal and Installation.
Is the inspection result normal?
INSPECTION END
.
 
3.REPLACE POWER WINDOW MAIN SWITCH
Replace power window main switch. Refer to Removal and Installation.
Is the inspection result normal?
INSPECTION END
.
 
4.REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Is the inspection result normal?
INSPECTION END
.
 
5.CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to Intermittent Incident Intermittent Incident.
: INSPECTION END