[Previous][Next]
Removal and Installation
Pre-removal and Post-installation Operation
Dash Side Finisher Removal and Installation (Refer to INTERIOR TRIM Removal and Installation).
 
 
Removal steps
1.Instrument mask
2.Instrument pad
•Cluster lid assembly (Refer to Removal and Installation).
3.Side ventilator grille assembly
4.Side ventilator grille
5.Center ventilator grille
6.Electric motor switch
7.Hazard switch
8.Instrument finisher
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> INSTRUMENT MASK REMOVAL
Remove the clips shown in the illustration using special tool MB990784.
 
 
 
<<B>> INSTRUMENT PAD REMOVAL
Remove the clips shown in the illustration using special tool MB990784.
 
 
 
<<C>> SIDE VENTILATOR GRILLE ASSEMBLY REMOVAL
1. Remove the installation screws.
2. Remove the clips shown in the illustration using special tool MB990784.