[Previous][Next]
P1C08-15 Ambient Temp Sensor Open Fault/Supply Fault
 
 
cautionBefore replacing the ECU, ensure that the CAN bus lines is normal.
 
 
DESCRIPTIONS OF MONITOR METHODS
Failure of Ambient Temperature Sensor Range is judged by voltage of sensor.
 
 
MONITOR EXECUTION
Continuous
 
 
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
  • Not applicable
Sensor (The sensor below is determined to be normal)
  • Not applicable
 
 
DTC SET CONDITIONS
Logic Flow Chart
 
 
TROUBLE JUDGMENT
Check Condition
  • The heater PHEV A/C amp. power supply voltage is between 10 and 16 volts.
Judgment Criterion
  • Change the ambient sensor(for PHEV A/C amp.) voltage is more than 4.9 volts for 3 seconds.
 
 
OBD-II DRIVE CYCLE PATTERN
 
 
PROBABLE CAUSES
  • Malfunction of harness and connectors
  • Malfunction of ambient sensor (for PHEV A/C amp.)
  • Malfunction of PHEV A/C amp.
 
 
DIAGNOSIS PROCEDURE
1.Voltage measurement at ambient sensor (for PHEV A/C amp.) connector (terminal No. 2)
(1) Disconnect the connector, and measure at the wiring harness side.
(2) Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
(3) Measure the voltage between the ambient sensor (for PHEV A/C amp.) connector (terminal No. 2) and body ground.
OK : About 5 V
Is the inspection result normal?
 
2.Check of open circuit in T_AMB line between PHEV A/C amp. and ambient sensor (for PHEV A/C amp.) sensor
Is the inspection result normal?
Repair harness or connector.
 
3.Voltage measurement at PHEV A/C amp. connector (T_AMB terminal)
(1) Disconnect the connector, and measure at the wiring harness side.
(2) Change the power supply mode of the electric motor switch to ON (READY indicator: ON).
(3) Measure the voltage between the PHEV A/C amp. connector (T_AMB terminal) and body ground.
OK : About 5 V
Is the inspection result normal?
Repair harness or connector.
 
4.Check of open circuit between ambient sensor and body ground.
Is the inspection result normal?
 
5.Check of open circuit in SG line between PHEV A/C amp. and ambient sensor (for PHEV A/C amp.) sensor
Is the inspection result normal?
Repair harness or connector.
 
6.Check the ambient sensor (for PHEV A/C amp.)
(1) Measure the ambient temperature near the ambient sensor.
(2) Measure the resistance between the ambient sensor terminals.
(3) Check that the ambient sensor properly detects the ambient temperature using the measurement result of (1) and resistance value of (2).
Is the inspection result normal?
Replace ambient sensor (for PHEV A/C amp.). Refer to Removal and Installation.
 
7.Test the OBD-II drive cycle.
(1) Carry out a test drive with the drive cycle pattern. Refer to OBD-II Drive Cycle - Pattern 4 OBD-II DRIVE CYCLE.
(2) Check the DTC.
Is the DTC set?
Replace PHEV A/C amp. Refer to Removal and Installation.
The trouble can be an intermittent malfunction. Refer to General Information - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunctions HOW TO COPE WITH INTERMITTENT MALFUNCTIONS.