[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C105D7BBrake fluid level low
(Brake fluid level low)
1Diagnosis condition
  • When electric motor switch is ON.
  • When the power supply voltage is normal.
Signal (terminal)Brake fluid level switch signal
ThresholdWhen brake fluid level low signal is detected.
Diagnosis delay time5 seconds or more
2Diagnosis condition
  • When electric motor switch is ON.
  • When the power supply voltage is normal.
Signal (terminal)Brake fluid level switch signal
ThresholdWhen an open circuit is detected in brake fluid level switch circuit.
Diagnosis delay time5 seconds or more
 
 
POSSIBLE CAUSE
noteConfirm if DTC is Stored DTC or Active DTC. If DTC is Active DTC, proceed with Diagnosis Procedure. If DTC is Stored DTC, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a Stored DTC DTC.
Stored DTC DTCActive DTC DTC
  • Brake fluid level is low
  • Harness or connector
  • Brake fluid level switch
  • Combination meter
  • Brake fluid level is low
  • Harness or connector
  • Brake fluid level switch
  • Combination meter
  • ABS actuator and electric unit (control unit)
 
 
FAIL-SAFE
The following functions are suspended.
  • ASC function
  • TCS function
  • Brake limited slip differential (BLSD) function
  • Brake assist function
  • Brake force distribution function
  • hill start assist function
  • Hill Descent Control funciton
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE" has been previously conducted, always electric motor switch OFF (Auto ACC function OFF) before conducting the next test.
: .
 
2.CHECK DTC DETECTION
With M.U.T.-III SE
  1. Electric motor switch OFF (Auto ACC function OFF).
  2. Electric motor switch ON.
    noteWait at least 10 seconds after electric motor switch ON.
  3. Perform Diagnostic Trouble Code for “ABS".
Is DTC “C105D-7B" detected?
-1“Active DTC" is displayed: Refer to Diagnosis Procedure.
-2“Stored DTC" is displayed: INSPECTION END (Erase the memory of Diagnostic Trouble Code results.)
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END